Specifications

6
Parts & Service: 020 8988 7400/E-mail:[e-mail] or [e-mail]
UNPACKING AND ASSEMBLY
Before assembling, please check contents against the following list and
advise your dealer immediately if any parts are missing.
1 x Heater
2 x Legs
1 x Handle
6 x Screws (supplied fitted)
1. Remove the screws from their
locations in the heater and use
them to attach each leg.
2. Repeat with the two remaining
screws to fit the handle as shown.
3. DO NOT use the heater without fitting the legs.
INSTRUCTIONS FOR USE
1. Place the heater on a firm, level
surface and following all safety
precautions, plug into a suitable
mains supply. The neon indicator
will illuminate.
2. Set one, or both switches to the I
(On) position as required.
• Two power settings are available.
Each switch will illuminate to show
that the upper or lower heat
element is in use.
• The output of each heating element is 1200 W (4100 BTU).
CAUTION; PLEASE NOTE THAT THE HEATING ELEMENTS OF THIS PRODUCT
DO NOT GLOW WHILST IN OPERATION. ANY PICTURES SHOWING THIS
IN ADVERTISING MATERIAL ARE FOR ILLUSTRATION ONLY.
NOTE: The heater is equipped with an anti-tilt switch that automatically
shuts the power off should the heater tip over. If this happens,
simply place the heater in its correct position and it will
immediately restart.
Screws
Handle
Legs
Neon Indicator
Switches