Specifications

8
1. Loosen and remove the two pozidrive screws securing the wire guard,
remove the guard and store removed parts safely.
2. To remove lamp, grasp lamp and gently but firmly push it to one end of
the heater. The lamp holders are spring loaded and will allow the lamp
sufficient movement to clear the opposite holder.
3. Remove the lamp and dispose of, according to local regulations.
4. Fit new halogen lamp in reverse order, repeat procedure for second tube.
5. Replace the guard using the screws removed earlier.
The heater is now ready for use again and may be plugged in and
switched on.
FAULT FINDING
melborP esuaCelbissoP ydemeR
tonseodretaeH
hguohtla,etarepo
dnanideggulp
.nodehctiws
dab/esoolsigulP
.noitcennoc
ehtkcehc&tuogulpe
htlluP
dnagulpehtfonoitcennoc
.tekcos
nwolbesuFdnayrassecenfiecalpeR
swolbesuffI.esuacetagitsevni
EKRALCruo
ytlusnoc,yldetaeper
.relaed
tekcostarewopoN
.teltuo
elbatiusanigulpehttresnI
.tekcos
sihctiwsytefastliT
.tin
ugnilbasid
hctiwsfI.thgirpusitinuerusnE
ruoytlusnoc,tes-ertonseod
.relaedEKRALC
tnemelegnitaeH
.tohgniwolg
hgihootegatlovtupnI
.wolootro
niylppusrewopaesU
gnitarehthtiwecnadrocca
.lebalehtno
yltrapsitelniriA
.dekco
lb
yawatpeksiretaehehterusnE
slairetamrostcejboynamorf
ehtrevocyllaitrapdluochcihw
.tiotninwardebrodrauge
riw
For parts & Servicing, please contact your nearest dealer, or
CLARKE International, on one of the following numbers.
PARTS & SERVICE TEL: [phone]
PARTS & SERVICE FAX: [phone]
or e-mail as follows:
PARTS: [e-mail]
SERVICE: [e-mail]