Specifications

7
CLEANING & MAINTENANCE
ALWAYS allow the heater to cool down for at least 15 minutes and disconnect
from the mains supply before performing any maintenance tasks.
PERIODICALLY
• Inspect the mains cable for damage. Undue heat will cause the cable to
stiffen and crack. If this is found, have the cable replaced. Check cable
routing and ensure it is well away from the heat source.
• Disconnect from the mains supply, remove the guard and wipe the
reflector and elements with a clean damp cloth. DO NOT use abrasive
cleaners. Take care that no moisture enters the heater.
• Refer to your CLARKE dealer if internal maintenance is required.
• When storing the heater, allow it to cool down, then place it in its packing
box for storage in a dry, ventilated place.
CERAMIC ELEMENT REPLACMENT
Ceramic elements are long lasting and should not need replacing under
normal circumstances. Should this become necessary take the heater to your
Clarke dealer.
For parts & Servicing, please contact your nearest dealer, or
CLARKE International, on one of the following numbers.
PARTS & SERVICE TEL: [phone]
PARTS & SERVICE FAX: [phone]
or e-mail as follows:
PARTS: [e-mail]
SERVICE: [e-mail]