Instruction manual
8
UNPACKING
When unpacking, check for damage or omissions etc. Any found should be
reported to your CLARKE dealer where the appliance was originally
purchased. Do not discard the packaging until the machine is assembled.
The following items are supplied loose:
1 x Lathe
1 x Tool Rest, 110mm
1 x Tool Rest, 170mm
1 x Face Plate, 145mm dia
1 x Headstock Centre Spur
1 x Tailstock Centre Spindle
1 x Tailstock Locking Lever
1 x Tool Spindle Locking Lever
1 x Tool Rest Support Locking Lever
1 x Toolrest Locking Lever
1 x Fixings Pack
1 x Drift Rod
1 x Open Spanner
2 x Allen Keys (3mm & 5mm)
1 x Instruction Manual (this document)