Instruction manual

UNPACKING & ASSEMBLY

When unpacking, check for damage or omissions etc. Any found should be

reported to your CLARKE dealer where the lathe was originally purchased. Do

not discard the packaging until the lathe is assembled.

WARNING: DUE TO THE WEIGHT OF THE LATHE BED ASSEMBLY, IT IS

ESSENTIAL THAT TWO PEOPLE PERFORM THE UNPACKING, ASSEMBLY

AND POSITIONING.

The numbers in the following assembly instructions refer to the parts lists and

diagrams on pages 18-22.

The following items are supplied loose:

1 x Lathe c/w Tailstock & Tool Carrier

1 x Tool Rest

1 x Tool Rest Holder

1 x Face Plate

1 x Headstock Centre Spur

1 x Tailstock Spur Assembly

1 x Copy Follower Assembly

1 x Tool Holder Locking Handle

3 x Leadscrew Handles

1 x Open Wrench

1 x Eye Shield Assembly

1 x 10mm T-Wrench

2 x Hex Keys (S3 & S4)

1 x Drift Rod

2 x Cutting Tools

3 x Wood Chisels

1 x Fixings Pack

2 x Stand Front Legs

2 x Stand Rear Legs

2 x Stand Long Supports

2 x Stand Short Supports

2 x Stand Top Plates

1 x Stand Shelf Plate

1 x Instruction Manual (this document)