Instruction manual

12
ASSEMBLING THE COPY TOOL
1. Install the copy toolholder rack
(64) into the hole in the copy
follower body (53) and drive it
through using the handwheel (1)
and the pinion gear (71) inside
the copy follower body.
2. Insert your chosen cutting tool
into the tool holder and tighten
the retaining bolt (118) using the
T- wrench as shown in Fig 7.
3. Advance the tool to the workpiece and
secure with the locking handle (59). The
tool tip should be at the same
height as the centre axis of the lathe.
4. Fit the eyeshield (115) to the copy follower
body using the socket-headed bolt (37) as
shown in Fig 8.
ASSEMBLING THE HAND CHISEL REST
If the copy system is not being used, the
standard tool rest for hand chisels can be
used as follows:
1. Set the chisel rest holder (101) on the lathe
bed and secure in position with the
securing plate (108) and the bolt/washer
(94/95) as shown in Fig 9.
2. Position the working edge of
the rest (100) level with the
centre axis of the lathe and
secure with the locking lever.
3. Position the rest level slightly
above the lathe centreline
and approx 3mm from the
workpiece and tighten the
locking handle (59) to secure.
The rest can be used parallel
with the workpiece or at 90
degrees for faceplate turning.
Fig 7
Fig 8
Fig 9