Instruction manual

11
4. Fit the leadscrew hub (79) onto
the leadscrew axle (78) and
secure with a grub-screw (50).
If not already fitted, screw the
leadscrew handles (113) into the
leadscrew hub (79) and tighten
by hand as much as possible.
ASSEMBLY OF THE COPY FOLLOWER
If the copy system is to be used
proceed as follows;
1. Position the copy follower body
(53) over the lead screw 3-way
trunnion (77) and connect it using
the copy pivot stud (73) and
tighten the nuts on each side as
shown in Fig 5.
2. Connect the copy tension spring
(68) to the locating hole in the
spring attachment plate (55).
3. Pass the slot-headed bolt (67)
through the other end of the
spring before screwing it into the
tip of the leadscrew axle (78) as
shown in Fig 6.
Fig 4
Fig 5
Fig 6