Owner`s manual

25
Parts & Service: 020 8988 7400 / E-mail: [e-mail] or [e-mail]
CROSS CUTS
1. Slide the mitre gauge into one of
the grooves in the table.
2. Adjust the mitre gauge to the
required angle.
3. If you also want to tilt the blade,
use the groove which prevents
your hand and the mitre gauge
from making contact with the
blade guard.
4. Press the workpiece firmly against
the mitre gauge.
5. Switch on the saw.
6. Push the mitre gauge and the workpiece toward the blade to make the
cut.
IMPORTANT: Always hold the guided part of the workpiece. Never hold the
part which is to be cut off.
7. Push the mitre gauge forward until the workpiece is cut all the way
through.
8. Switch off the saw. Do not remove the offcut until the blade has stopped
rotating.