Owner`s manual

24
Parts & Service: 020 8988 7400 / E-mail: [e-mail] or [e-mail]
CUTTING NARROW WORKPIECES
Always use a push stick when the
workpiece is smaller then 120 mm in
width.
When not in use, place the push stick
in its storage clip on the side of the
saw.
Replace a worn or damaged push
stick immediately.
BEVEL CUTS
Bevel cuts must always be made using the parallel fence.
1. Undo the fixing handle.
2. Turn the handle to set the desired
angle on the scale.
3. Lock the fixing handle to lock the
blade at the selected angle.
4. Set the parallel fence.
5. Carry out the cut as you would for
a ripping cut.