Owner`s manual

22
Parts & Service: 020 8988 7400 / E-mail: [e-mail] or [e-mail]
BEFORE PUTTING THE MACHINE INTO OPERATION
• All covers and safety devices have to be properly fitted before the
machine is switched on.
• When working with wood that has been used before, watch out for
foreign bodies such as nails or screws etc.
• Before you switch on, make sure that the saw blade is correctly fitted
and that the machine's moving parts run smoothly.
• Before you connect the machine to the power supply, make sure
the data on the rating plate is the same as that for your mains
supply.
OPERATION
ON/OFF SWITCH
1. To turn the saw on, press the
green button “I”.
• Wait for the blade to reach its
maximum speed before
commencing with the cut.
2. To turn the machine off again,
press the red button “0”.
NOTE: The blade will spin for several
seconds after the machine is
switched off.
OVERLOAD RESET BUTTON
This table saw has a thermal overload device.
If the saw gets too hot, the thermal overload device cuts the power which
prevents damage to the motor.
If the thermal overload device operates, let the motor cool down for 5 minutes
and push the reset button located just above the ON (I) button
If you start the saw and the overload cutout operates again, stop the saw and
disconnect from the power supply and have your table saw examined by a
qualified service agent.