Owner`s manual

20
Parts & Service: 020 8988 7400 / E-mail: [e-mail] or [e-mail]
ADJUSTMENTS
After every new adjustment we recommend you to make a trial cut in order to
check the new settings.
PARALLEL FENCE
FENCE HEIGHT
The parallel fence has two different guide faces.
• For thick material you should use the high side of the parallel fence.
• For thin material you should use the low side of the parallel fence.
To change the parallel fence from
one to the other you have to:
1. Loosen the two knurled screws.
2. Remove the parallel fence from
the holder.
3. Remount the parallel fence on
the holder by sliding the holder
into the relevant mounting slot.
4. Retighten the two knurled
screws.
CUTTING WIDTH
The parallel fence can be mounted on either side of the saw table. If you do
change the side, you will need to flip the parallel fence to the other side of the
holder.
1. Place the parallel fence into the
guide rail of the saw table.
2. Use the scale on the guide rail to
set the parallel fence to the
required distance from the blade.
3. Clamp the parallel fence in the
required position by pressing
down on the lever.