Owner`s manual

17
Parts & Service: 020 8988 7400 / E-mail: [e-mail] or [e-mail]
CHANGING THE BLADE
1. Remove the table insert by
undoing the countersunk screws.
2. Insert a screwdriver into the hole in
the table.
• This acts as a spindle lock
3. Undo the blade retaining nut with
a suitable spanner.
• Turn the nut in the direction of
rotation of the saw blade.
4. Take off the outer flange and pull
the old saw blade off the inner
flange by dropping the blade at
an angle.
5. Clean the blade mounting flange
thoroughly before fitting the new
blade.
6. Mount and fasten the new blade
in reverse order.
IMPORTANT: Note the running
direction. The cutting angle of the teeth must point in running direction, i.e.
forwards (see the arrow on the blade guard).
7. Replace the riving knife and the saw guard.
8. Check to make sure that all safety devices are properly mounted and in
good working condition before you begin working with the saw again.
WARNING: REMOVE THE PLUG FROM THE MAINS SUPPLY BEFORE
CARRYING OUT ANY ADJUSTMENT, SERVICING OR MAINTENANCE