Owner`s manual

16
Parts & Service: 020 8988 7400 / E-mail: [e-mail] or [e-mail]
FITTING THE RIVING KNIFE
1. Turn the hand crank
counterclockwise until the blade
is at its maximum setting.
2. Remove the countersunk screws.
and lift the table insert away from
the table saw.
3. Slacken the fixing screw and slide
the riving knife behind the bracket
as shown.
4. Lightly tighten the fixing nut.
5. Adjust the riving knife position until
the distance between the blade
and the riving knife is between 3-8
mm.
6. Retighten the fixing screw fully
and replace the table insert.