Owner`s manual

15
Parts & Service: 020 8988 7400 / E-mail: [e-mail] or [e-mail]
SETTING UP THE TABLE SAW
1. Release the stand locking latch.
2. Raise the legs as shown.
NOTE: Take care as the lower set of
legs may fall towards you.
3. Secure the legs in place using the
latches at the top of the legs.
4. Lift the table saw allowing the
remaining set of legs to swing
under and out towards you as
shown.
5. Secure the legs in place using the
latches at the top of the legs.
6. Swing the stabiliser legs into the
open position and secure using the latch shown below.