Owner`s manual

13
Parts & Service: 020 8988 7400 / E-mail: [e-mail] or [e-mail]
7. Push the tongue on the extension
table into the grove on the table
top.
8. Make sure the you place the
joining bracket over the coach
bolt inserted in step 6.
9. Add a washer and nut, tighten
the nut just enough to hold the
extension table in place.
10. Repeat steps 6-8 with the left
extension table.
FITTING THE EXTENSION TABLE SUPPORTS
11. Insert the four locking plates into
the sockets on the table saw body
(2 each side).
12. Using a suitable screwdriver,
remove the black clip located on
the corner of the extension table.
13. Slide in two coach bolts into each
extension table.
• Do not place any downward
pressure on the extension
tables.