Specifications

8
Parts & Service: 020 8988 7400 / E-mail: [e-mail] or [e-mail]
ASSEMBLY
FITTING AND REMOVING SANDING BELTS
1. Move the belt tensioning lever to
the front position.
2. Place the sanding belt over the
front pulley and the rear pulley,
sliding it through the slot in the
housing
• Make sure that the arrows on
the inside of the sanding belt
face the same direction as the
arrows on the housing.
3. Move the belt tensioning lever to
the rear position.
4. Adjust the belt tracking as
described See page 9.
WARNING: BEFORE ASSEMBLY, MAKE SURE THAT THE TOOL IS SWITCHED
OFF AND UNPLUGGED.
CPF13 Electric Power File.fm Page 8 Wednesday, February 29, 2012 10:50 AM