Specifications

12
Parts & Service: 020 8988 7400 / E-mail: [e-mail] or [e-mail]
MAINTENANCE
• Your tool has been designed to operate over a long period of time with
a minimum of maintenance. Continuous satisfactory operation depends
upon proper tool care and regular cleaning.
• Regularly clean the ventilation slots in your tool using a soft dry brush or
dry cloth.
• Regularly clean the motor housing using a clean damp cloth. Do not use
any abrasive or solvent-based cleaner.
CHANGING THE CARBON BRUSHES
Occasionally remove and inspect
the motor brushes and replace if
necessary.
When removing brushes, note which
way round they are. The brushes must
be returned exactly the same way.
Never allow the brushes to wear
more than two thirds of their original
length, (new brushes are
approximately 13 mm long), fit new brushes when or before they are worn
down to 5 mm.
VIBRATION
The declared vibration emission values stated in the specifications have been
measured in accordance with a standard test method provided by EN 60745
and may be used for comparing one tool with another. The declared vibration
emission value may also be used in a preliminary assessment of exposure.
WARNING: BEFORE PERFORMING ANY MAINTENANCE, SWITCH OFF AND
UNPLUG THE TOOL.
WARNING: THE VIBRATION EMISSION VALUE DURING ACTUAL USE OF THE
POWER TOOL CAN DIFFER FROM THE DECLARED VALUE DEPENDING ON
THE WAYS IN WHICH THE TOOL IS USED. THE VIBRATION LEVEL MAY
INCREASE ABOVE THE LEVEL STATED.
CPF13 Electric Power File.fm Page 12 Wednesday, February 29, 2012 10:50 AM