User guide

USING YOUR STOVE

THE CONTROLS

The amount of heat emitted by the stove is regulated using the following air

controls:

A) The primary air supply is

controlled using the two

lower air controls built into

the door.

B) A second air inlet provides

a constant, pre-heated air

supply to the combustion

just above the fire. This is

controlled using the upper

air control mounted near

the top of the stove. This air

supply will not normally

need to be regulated so will

usually be kept open.

C) An additional air inlet is

provided in the base of the

stove. This is controlled using

the knob at the bottom of

the stove to provide a

gentle updraught from the back of the stove to the chimney flue.

D) The knob on the left is for riddling (moving) the grate panel to dislodge

any accumulation of loose ash into the ash pan.

WARNING: THE TEMPERATURE REACHED BY THESE ITEMS DURING

OPERATION MAY CAUSE AN INJURY TO AN END-USER. AS THESE ARE

INTENDED TO BE ADJUSTED DURING OPERATION, IT IS RECOMMENDED

THAT PROTECTIVE GLOVES ARE WORN WHEN HANDING THESE PARTS.

TYPES OF FUEL

This stove will function with wood or coal, but in general all fuel should be dry

and timber should be well seasoned so as to have a moisture content below

20%. The use of damp wood will result in more soot and tar deposits being left

in the chimney, flu and stove, and will not release heat if thermal energy is

being used to drive out moisture from the fuel.

Other fuels can be used together with wood, provided the base of the fire

remains as wood or compressed block fuels. Coal products can be added to

this provided the volume of coal products is less than that of other fuels.

Fig 11