Specifications

Enter the screw with washer
down though the hole in the
bed (See Fig.5, and B, Fig.3),
and screw on the clamp from
below by a few turns, open
channel upwards.
Slide the work support into place
between the underside of the
bed and the clamp and tighten
the screw. Take care not to slide
the work support too far. The
position is correct when the
upturned ends of the support
A. Cross Cutting. (at 90°) Ref: Fig. 7
First, set the work in place. Clamp it firmly against the table and back
fence. Check the security of the Bevel Lock shown at C, Fig 16, page 16,
and tighten the handle if necessary, also ensure the table is locked using
the table locking handle.
NOTE: If the workpiece is not entirely straight, ensure that the portion at
either side of the intended cut rests firmly against the table and back
fence.
are directly in line with the table surface.
Attach the dust bag to the dust extraction outlet with its spring clip.
If required, the work clamp, shown in fig. 6 is mounted in holes ‘B’ fig. 3.
Fig. 6
It is important to ensure that one
end of the workpiece is
completely free to move i.e. NOT
clamped or held in any way. This
will normally be the off-cut or
shorter end.
When satisfied, make a final
check to ensure that all safety
precautions are being complied
with, then pull and hold the
Trigger Release - A, whilst pulling
the Trigger - B, to start the motor.
OPERATON
Fig. 7
11