Specifications

.....then screw the Draw Bar (‘A’Fig.9),

down through the spindle and into

the arbor - fully.

Secure by tightening the locknut (‘B’

Fig.9).

• The chuck may now be located on the morse tapered arbor. Tap home using a

block of wood ONLY.

• Screw the Spindle Cover (‘C’ Fig.9) into the pulley cover and place the cap on top

• Screw the two handles (‘C’ Fig.10) into the spindle feed hub and tighten.

NOTE: A locking lever (‘E’ Fig.10) secures the Mill Head. By slackening the lever, the

Mill Head may be rotated about the Headstock - convenient for moving it out of

the way during turning operations.

Fig.9

Fig.10

A .... Spindle Feed Dog Clutch

B ..... Spindle Microfeed Handle

C .... Spindle Feed Handle

D ..... Mill Head Raising Lever

E ..... Mill Head Locking Lever

F ..... Spindle Locking Lever

G .... Drive Belt Adjuster

H ..... Spindle Sleeve Locating Peg

Fig.8

• Slide the Arbor into the spindle

and push home - fully (Fig.8)......