Specifications

12
Parts & Service: 020 8988 7400/E-mail:[e-mail] or [e-mail]
TIGHTENING A NUT
1. Start the nut by hand, ensuring it is not cross threaded, then with the
appropriate socket installed on the wrench, place it on the nut.
2. With the FORWARD/NEUTRAL/REVERSE switch-bar in the forward running
position, and holding the wrench firmly in BOTH HANDS, pull the trigger.
3. Run each nut up in turn until it is ‘nipped’ up only - do not tighten. When
all nuts are nipped up, tighten progressively by pulling the trigger fully and
allowing the action to operate for only 3 to 4 impacts to prevent
overtightening.
4. ALWAYS finish tightening with a torque wrench. The weight of the vehicle
will need to be placed on the wheel to prevent it from rotating while the
nuts are tightened. Ensure the final torque applied to the nuts meets the
vehicle manufacturers recommendations.
MAINTENANCE
1. Ensure all fixings remain tight to ensure the machine is in safe working
condition.
2. Check the battery charger power cable to ensure it is free from cracks,
bare wires etc.
3. Avoid using solvents when cleaning plastic parts, most plastics are
susceptible to damage from the various types of commercial solvents.
Keep the unit clean by wiping with a dry cloth.
• All bearings etc, in this machine are lubricated with a sufficient amount of
high grade lubricant for the machines lifetime under normal operating
conditions, therefore no further lubrication is required.
• Refer to your CLARKE dealer if internal maintenance is required.
• Your Clarke impact wrench has been designed to give long and trouble
free service. If, however, having followed the instructions in this booklet
carefully, you encounter problems, take the unit to your local Clarke
dealer.
STORAGE
• Make sure that the machine is stored in a clean, dry place, out of reach of
children when not in use.
• Always store the machine and its charger in the case supplied.