2VDC TO 230VAC INVERTERS MODEL Nos: CI-200 • CI-400 • CI-600 • CI-800 • CI-1000• CI-1500 OPERATION & MAINTENANCE INSTRUCTIONS 0706
Thank you for purchasing this CLARKE Power Inverter. Before attempting to use the Inverter, please read this manual thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to the machine giving you long and satisfactory service. CLARKE GUARANTEE This CLARKE product is guaranteed against faulty manufacture for a period of 12 months from the date of purchase. Please keep your receipt as proof of purchase.
Safety Precautions WARNING: To ensure reliable service from your power inverter, you must ensure it is installed and used according to these operator instructions, please read these instructions thoroughly before attempting to use the inverter. Pay particular attention to the WARNING and CAUTION statements in this manual. CAUTION statements advise against certain conditions and practises that could result in damage to your inverter.
1. INTRODUCTION Your new inverter is one in a series of the most advanced DC to AC inverters available today. With proper care and appropriate usage, it will give you years of dependable service in your car, truck, RV or boat. The inverter supplies continuous 230V, 50Hz power via a standard 3-pin socket whenever and wherever it is required.
3.2. The Output Waveform The AC output waveform of the inverter is known as “modified sine wave”. It is a waveform that has characteristics similar to the sine wave shape of utility power. This type of waveform is suitable for most AC loads, but may not be suitable for scientific equipment. Always consult the manufacturers manual where necessary.
Connecting to source using cigarette lighter plug: The cigarette lighter plug is suitable for operating the inverter at power outputs up to 150 watts. The tip of the plug is positive and the side contact is negative. Connect the inverter to the power source by inserting the cigarette lighter plug firmly into the cigarette lighter socket of a vehicle or other DC power source. Connect directly to power source when operating above 150 Watts.
4.4. Placement of the Inverter For best operating results, the inverter should be placed on a flat level surface. 3 feet (1.0 meter) cables are provided allowing for easy positioning of the inverter. The inverter should only be used in locations that meet the following criteria: DRY - Do not allow water and/or other liquids to come into contact with the inverter. COOL - Ambient air temperature should be between -1OC (30O F) and 40OC, (105OF).
6. PROTECTION FEATURES OF INVERTER Your inverter monitors the following potentially hazardous conditions: Low Battery Voltage - This condition is not harmful to the inverter but could damage the power source. An audible alarm will sound when input voltage drops to 10.5 volts. The inverter automatically shuts down when input voltage drops to 10.0 volts. When the condition is rectified, the unit may be restarted.
8. TROUBLESHOOTING FAULT No AC output - red LED illuminated POSSIBLE CAUSE DC input below 10Volts Excessive load - thermal shutdown REMEDY Recharge or replace battery Reduce load - wait for inverter to cool. Turn Off, then turn On No AC output Inverter cold Disconnect load from inverter. Operate inverter without load for a few minutes. Reconnect load.
