Operating instructions

• The pressure regulator should

be set at its lowest setting, i.e.

turned fully anticlockwise. (- &

+ arrows are shown on the

knob)

• If the compressor has not been

used recently, open the drain

valve shown in Fig 1 to drain

any condensate which may

have accumulated. When

clear, close the valve, finger

tight.

IMPORTANT: If the receiver is under pressure, keep your hands well away from

the air being expelled. Remember, compressed air is DANGEROUS!

WARNING! BEFORE CONNECTING ANY AIR TOOL, MAKE SURE YOU

HAVE READ AND FULLY UNDERSTOOD THE MANUFACTURER’S

INSTRUCTION BOOKLET FOR THE AIR TOOL BEING USED. ALSO ENSURE

THAT THE AIR TOOL IS COMPATIBLE WITH THE COMPRESSOR AND HOSE

SPECIFICATIONS.

IF THE PRESSURE RATING OF THE TOOL IS LESS THAN 10 BAR, THE

PRESSURE REGULATOR MUST BE USED TO ADJUST THE OUTPUT PRESSURE.

1 Connect a suitable air hose to the

compressor outlet and the other

end to the equipment to be used.

2. Attach the air hose to the air

outlet using the hose nut as shown

in Fig 2.

3. Ensure that the drain valve is

closed finger tight as above.

4. Ensure the ON/OFF switch is in the

OFF position, i.e. pushed down,

then plug in the machine and

switch ON at the mains supply.

Fig 1

Fig 2