Operating instructions

PREPARATION FOR USE

WARNING: Before using the compressor, make sure that you have

read and understood the safety instructions.

UNPACKING

Take care when lifting the compressor from the packaging and get

assistance if necessary to avoid personal injury or damage to the machine.

Always lift using the handle and frame.

Caution! Never take the weight of the compressor by the regulator /pressure

control switch. Get assistance if necessary.

After removing the compressor from its packaging, check that it has not

been damaged in transit.

POSITIONING THE COMPRESSOR

This compressor should be positioned on a stable, flat surface.

Note: the compressor should not be operated on a steep slope or floor

angle of greater than 15

If the compressor is placed on a shelf or raised off the ground, it should be

secured appropriately to prevent it from falling off during use.

Do not cover the compressor. Always position it with good all-round air

ventilation.

MOVING THE COMPRESSOR

When moving the compressor;

• Always use the handle.

• Do not lift by (or place a strain on) the air regulator fittings, hose or

cables.

• Take care when moving the compressor to avoid damaging the

valves or fittings.

• Always switch it off and disconnect it from the mains power supply.

CONNECTION AND START UP

Before connecting your compressor to the mains supply, check the

following:-

• The supply voltage must be 110V (Champ 110 V - Part No; 2225220)

or 230V (Champ 230 V - Part No; 2225215).

• The ON/OFF switch is in the OFF (depressed) position.