Specifications

UNPACKING
Unpack the shipping carton, and lay out the components so that they can be
clearly identified. Check them off as follows:
5
1. Chisel Sets -4 off (see Accessories)
2. Chisel Holder
3. Chisel Holder Collars Hold Down
4. Hold Down
5. Hold Down Support
6. Hold Down Post
7. Fence
8. Mounting Bolts w/Wing Nuts
and 2 x Flat Washers - 2 off
9. Workpiece Securing Hooks - 2 off
Should there be any deficiency or damage to any of the components, please
contact your Clarke dealer immediately
5
* Place the workpiece on to
the table, up against the
fence, then attach the two
Hooks in the manner shown,
pulling the workpiece up
against the fence.
DO NOT force the
workpiece, it should be
firm, but allowed to move
laterally, by hand.
• Lower the Hold Down so
that it makes contact
with the workpiece.
Again DO NOT force the
hold down - the
workpiece should be
allowed to move laterally
by hand.
6
Lower the chisel and bit, (or raise
the table) so it is directly above the
proposed Mortise.
NOTE:
If your table is capable of rotating
about the column, ensure it is
secured with the hole in the table
directly beneath the chisel.
If you have a round table with
radial slots, which rotates about its
axis, you need to lock the table in
a position where the assembly can
be manoeuvred, in the radial slots,
so that the proposed Mortise lies
directly beneath the chisel.
You should always mark your
Mortise on the workpiece clearly,
beforehand.
The chisel must be square with the workpiece, as shown. Move the complete
assembly on the table until you are satisfied it is, then clamp the complete assembly
to the table using the wing nuts on the hold down support securing bolts.
Your Morticing Attachment is now set up and ready for use.
8