Specifications

10
Parts & Service: 020 8988 7400 / E-mail: [e-mail] or [e-mail]
MOUNTING AND USING THE PARALLEL GUIDE
MOUNTING
1. Slide the parallel guide into the
base plate as shown.
2. Secure in place using the parallel
guide locking screw.
ADJUSTING
1. Loosen the Parallel Guide Locking
Screw.
2. Adjust the Parallel Guide to the
required length.
• There is a scale on the parallel guide that can be used to give an
approximate guide. always double check using an accurate ruler.
3. Tighten the Parallel Guide Locking Screw to secure the parallel guide in
position.
DUST EXTRACTION
The circular saw can be connected
to a dust extraction system, using a
suitable hose adaptor (not supplied).
• The internal diameter of the
dust extraction outlet is 30mm.
CCS185 Circular Saw.fm Page 10 Monday, December 12, 2011 3:39 PM