Owner`s manual

I. UNPACKING AND CHECKING CONTENTS
A. Basic saw assembly
B. Owners Manual
C. Saw Table assembly
D. Bag Assembly
/
Containing the following parts:
1. Switch, Key
2. Nut, Wing 1/4-20
3. Screw, Truss Hd. 1/4-20 x 3/4
4. Washer 67 x «i16 x tf6
5. Wrench, Hex. "L" 3 MM
6. Wrench, Hex. "L" 5 MM
7. Washer 17/64 x 47/64 x 1/16
8. Indicator, Bevel
9. Screw, Pan Cross #10-24 x 3/8"
10. Insert, Table
11. Knob
Note: If you find any parts missing or damaged, contact the dealer for exchange
replacement.
-2-
1. Tension adjusting knob . . . Tightening the knob (clockwise) will
;
increase the tension on the
blade. Loosening it (counter clockwise) will decrease the tension. (Tension lock knob must
be released).
2. Cover knobs . . . Secure cover to frame by tightening all three (3) cover knobs.
3. Blade Guides . . . Supports the blade and keeps it from twisting during operation. An
adjustment is necessary when blades are changed or replaced.
4. Tension lock knob . . . Holds position of the upper wheel which is set by the tension
adjusting knob.
5. Guide bar lock knob . . . The upper blade guide assembly should just clear the work-piece
while cutting. Always adjust the upper guide assembly and lock the guide bar by tightening
the blade guide lock knob before turning on the band saw.
6. Table lock knobs . . . Loosening knobs allows the table to be tilted and tightening knobs
locks the table in place.
7. Tilt (bevel) scale . . . Shows degree table is tilted for bevel cutting.
8. ON-OFF SWITCH. The On-Off Switch has a locking feature. THIS FEATURE IS
INTENDED TO HELP PREVE NT UNAUTHORIZED AND POSSIBLY HAZARDOUS
USE BY CHILDREN AND OTHERS.
-3-
M. TO KNOW YOU
R BAND SAW
Unpack carton, check your machine, to see parts listed below: