Specifications

4
ELECTRICAL CONNECTIONS
WARNING
THIS EQUIPMENT MUST BE EARTHED
This appliance, which is provided with a 3-pin BS 1363 plug, should be connected
to a standard domestic 13 amp, 230 volt (50Hz), electrical supply and we strongly
recommend that this be done through a Residual Current Device (RCD).
Should the plug require renewing at any time, the wires should be connected in
accordance with the following colour code:
Green & Yellow .............. Earth or marked with a letter “E” or Earth symbol “ ”
Blue .................................. Neutral or terminal marked with a letter “N”
Brown ..............................Live or terminal marked with a letter “L”
FUSE RATING
The fuse in the plug must be replaced with one of the same rating (13 amps)
and this replacement must be ASTA approved to BS1362.
IMPORTANT:
If this appliance is fitted with a plug which is moulded onto the electric cable (i.e.
non-rewirable) please note:
1. The plug must be thrown away if it is cut from the electric cable. There is a
danger of electric shock if it is subsequently inserted into a socket outlet.
2. Never use the plug without the fuse cover fitted.
3. Should you wish to replace a detachable fuse carrier, ensure that the correct
replacement is used (as indicated by marking or colour code).
4. Replacement fuse covers can be obtained from your local dealer or most
electrical stockists.
We strongly recommend that this machine is connected to the mains
supply through a Residual Current Device (RCD).
EXTENSION CABLES
Ensure that extension cable insulation is rubber or neoprene, and that the cross
section of each conductor is at least 2.5mm
2
. The maximum length of the cable
should not exceed 25 Metres.
If the electrical connections are outdoors, then the plug AND socket MUST be of a
BS approved waterproof design.
WARNING
DO NOT ATTEMPT ELECTRICAL INSTALLATION WORK IF YOU ARE IN ANY DOUBT AS
TO HOW IT SHOULD BE DONE PROPERLY. CONSULT A QUALIFIED ELECTRICIAN.