Instruction manual

15
Parts & Service: 020 8988 7400 / E-mail: [e-mail] or [e-mail]
SELECTING THE CORRECT GUARD
A single open guard is supplied with
the CAG2350B, suitable for grinding.
In accordance with the relavent
standards, an alternative 9” closed
guard is available for cutting discs.
(Clarke part no 6470156), or a quick-
release alternative, (Clarke part no
6470156).
The open guard should be used with
type 27,28 and 29 discs as follows;
• Type 27 -Depressed centre grinding wheels.
• Type 28 -Depressed centre grinding wheels cone shaped.
• Type 29 -Depressed centre semi-flexible wheels.
The closed guard should be used with type 1, 41 & 42 discs as follows;
• Type 1 - Straight grinding wheels.
• Type 41 - Flat cutting off wheels.
• Type 42 - Depressed centre cutting off wheels.
SUITABLE ABRASIVE AND CUTTING DISCS
The following Clarke discs are suitable for use with the CAG2350B. Always use
the correct disc and guard type for its intended task.
MAINTENANCE
GENERAL MAINTENANCE
1. Always have your angle grinder inspected and maintained by qualified
service personnel. Do not attempt to repair the angle grinder unless you
are qualified to do so.
2. Make sure that all nuts, bolts and screws are tight and secure.
3. Check the auxiliary handle and the guard for damage.
Use Model No Diameter Bore Part No
Cutting & Grinding PD2 (plasma) 230mm 22mm 3052055
Metal Cutting ----------------- 230mm 22mm 6470790
Metal Grinding ----------------- 230mm 22mm 6470720
Masonry Cutting ----------------- 230mm 22mm 6470750