Installation Sheet

Installation Planning and Preparation

1. Determine the final location of the tub. The tub will sit on top of the finished floor but the drain

(and overflow piping, if applicable) may sit below the finished floor. Tubs installed on a slab

foundation may require extra effort to gain clearance for installation.

2. Ensure location is structurally sound and can bear the weight of the tub when filled with water.

(Refer to page 6 for details regarding weight of tub & water capacity.)

3. Check to make sure the floor is level. An uneven floor may impede proper installation of the tub.

Use a 5 or 6 foot level to determine if the floor is level. If not, calculate how much

mortar/bedding material will be required to level the tub. The entire tub floor must be fully

supported.

4. Insure there is a drain rough in the proper location to allow the necessary clearance.

Note: some tubs come standard with integral

slotted overflows. Others come pre-drilled

for traditional round overflows. Be sure to

refer to actual product before installing, since

this may also be an “option” created at time

order was placed.

Illustration