Installation Sheet

6
ATTENTION INSTALLER!
This tub must be tested for leaks prior to installation. Failure to do so will void the warranty. This tub was
tested at the factory and found to be fully operational and leak-free prior to shipping. Shipping, handling, and
job site exposure may have deteriorated the tub’s condition. It is the responsibility of the installer to
thoroughly test the tub prior to installation.
Water Test Procedures
1. Place the tub on a level surface.
2. Seal the drain.
3. Fill the tub to the overflow.
4. Allow tub to stand for at least five minutes and then check for leaks.
5. If any leaks are discovered, do not complete installation until the issue is resolved. Clarke Products will
not be responsible for leaks after the tub is installed, or any cost involved with removing or reinstalling
the tub or the cost of any surrounding materials or labor.
Always protect the tub from construction damage. Damage, including chips and scratches, incurred at the
jobsite is excluded from the warranty, but may be repaired by a qualified individual at the owner’s expense.
Important: Proper waste and overflow (if applicable) installation is the responsibility of the installer.
Clarke Products does not warrant leaks associated with improper waste and overflow installation.
Rough-In Measurements for Freestanding Bathtubs
(Some tubs may have shipped with special drilling for standard overflow, see individual spec pages for details, available at www.clarkeproducts.com)
Note: All specifications are within ± ¼ ” tolerance. They are subject to change without notice. Clarke Products strongly recommends measuring
your specific tub on site. Refer to Illustration A on next page for how measurements have been taken.
Model Meas A Meas B Meas O
Slotted
Integeral
Overflow
Length Width
Height to
Deck (D)
Height
to Lip (H)
Dry weight
(lb)
Gal to
overflow
Victoria 4066O FS
(without base) 32 ½” 10 ½” 18” 65" 40" 22 1/4" 20" 75
70
Oval 6
+
35 ½” 13” 19 ½” 71" 40" 24" - 110
70
Crystalline 12” 18” 19” * Yes 72" 36" 20 1/2" - 376
99
Dune 10” 16” 18 ½” * Yes 59" 32" 27 1/2" - 263
72
Dune II 12 1/4 " 17” 19 ½” * Yes
68" 34" 29" - 347 93
Dune II Dimensional 12 1/4 " 17” 19 ½” * Yes
68" 34" 29" - 285 93
Irideon/Diamond 26 ½” 19” 19“ * Yes 71 1/4" 38 1/2" 21 5/8" - 365
169
K2 Oval 7034
+
35 1/4" 10" Yes 71 1/2" 35 1/2" 23" - 317
101
Lavasca Mini 32 ½” 18” 15” * Yes 63 3/4" 35 1/2" 22 1/2" - 284
48
Lavasca
35" 19 1/2" 16" * Yes 70 " 39" 23 7/8" - 244 69
Oval/Pearl 5836
8” 19” 16” No 58" 36 1/2" 19 1/2" 19" 155
71
(this design c an be freestanding or drop- in)
Ofuro 9 ½” 13 ½” 18” * Yes 55" 27 1/2" 21 5/8" - 288
66
Piro2
+
Spartan/Emerald 6030 7 ¼”
14
7
/
8
”
18 ½” * Yes 60" 30" 20 1/2" - 285
99
Sparta 6032 Drop-in 7 ¼”
15
3
/
4
”
16” * Optional 59 3/4" 32" 17" 16 1/2" 149
73
(this design is drop- in only, unless requested as a free standing or skirted unit)
Emerald 6032 Drop-in
” ”
13 1/2" No
” ” ” ” ” ”
Sparta 6030 Drop-in
+
Urban 8 1/2" 15" 13 3/4" * Yes 59 3/4" 30" 15 3/4" 15 1/4" 233
54
(this design is drop-in only, unless requested as a skirted unit)
+ design still pending * = unless stated otherwise, tub ships with factory installed slotted integral overflow as standard option.
Acrylic
Solid Surface