Installation Sheet

Unpacking the Unit

1. Inspect the Carton.

2. If you note carton damage, take a picture and contact the carrier immediately. Do not install a

damaged tub. Clarke Products is not responsible for damage during transit.

3. Immediately inspect the unit for damage even if there is no visible carton damage and

immediately report any damage to the distributor/manufacturer. Once the unit is installed and

there is surface damage visible, we will assume it was caused by the installer. Installers are

responsible for damage that occurs once the unit is set in place.

4. Remove all packaging material except for the protective plastic. The protective plastic was put on

the tub to help eliminate abrasions due to handling and should not be removed until you are

ready to inspect the tub just prior to installation.

Installation and Operation Guidelines

Read all instructions before installing the tub. Installer/product owner is responsible for complying with

all state and local codes. Warranty coverage will be void if the tub is not tested and installed as detailed

in these instructions. Clarke Products strongly recommends using licensed professionals to install these

products. Warning: Certain cleaning products will permanently damage the cosmetic surface of the

tub. Read cleaning product label carefully before using. Never use anything abrasive, aerosol sprays,

or metal scrapers.

BEFORE INSTALLING:

Remove the protective plastic and inspect tub thoroughly. The protective plastic was put on the tub to

help prevent abrasions/staining, and the cosmetic surface of the tub should be protected in some

manner after the protective plastic is removed

. A factory defect must be reported to the manufacturer

before the tub is installed. Defects or damage claimed after installation will be excluded from the

warranty.

Important: Measure the tub on site carefully. Specifications are subject to change without notice.

Clarke Products is NOT responsible for any preparatory labor or materials.

Warning: Solid surface bathtubs may be very heavy. Make sure you have adequate help to move/install

the tub before beginning. Clarke Products is not responsible for handling damage.