Operator`s manual

Clarke
®
Operator's Manual - Image 14 Page 5
DANGER: Machines can cause an explosion when operated near flammable materials and vapors. Do
not use this machine with or near fuels, grain dust, solvents, thinners, or other flammable
materials.
WARNING: You must have training in the operation of this machine before using it. READ THE
INSTRUCTION BOOK FIRST.
WARNING: Any alterations or modifications of this machine could result in damage to the machine or injury
to the operator or other bystanders. Alterations or modifications not authorized by the
manufacturer voids any and all warranties and liabilities.
WARNING: Do not use this machine as a step or furniture. Injury could occur to the operator.
WARNING: To avoid serious injury, use proper lifting procedures when lifting the machine.
WARNING: Make sure that all the labels, decals, warnings, cautions and instructions are readable. Replace
them when necessary by ordering them from Clarke.
WARNING: Do not use water that is hotter than 140
°
F.
WARNING: Improper discharge of waste water may damage the environment and be illegal. The United
States Environmental Protection Agency has established certain regulations regarding
discharge of waste water. Also, city and state regulation regarding this discharge may be in
effect in your area. Understand and follow the regulations in your area. Be aware of the
environmental hazards of chemicals that you dispose.
Introduction and Machine Specifications
The Image 14 is an extractor for cleaning carpet. The machine applies cleaning solution to the carpet and removes
dirty solution and soil from the carpet. The Image 14 is equipped with a power brush. The extractor has controls to
start the solution pump, and vacuum motor. This machine is intended for commercial use.
Specifications: Image 14
120V
Model 04120A
Electrical 120 V. 50/60 Hz
Solution Pump 45 PSI Bypass
Power Cable 35' 14/3-wire
Spray Jets 1 Quarter Turn Q.C.
Solution Tank Capacit 4 Gallon
Recovery Tank 4 Gallon
Waterlift/CFM 82"/97
Vacuum Tangential discharge,
1.25 HP, 2 stage
Brush Size 3½" x 11"
Brush Motor Size
1
/8 HP
Dimensions 31½" x 37" x 14"
Weight 55 lbs.
Shipping Weight 65 lbs.
Control Switch
Recovery Tank
Recovery Tank Handle
Vacuum Hose
Solution Tank
Recovery Tool
Self Adjusting Brush
Locking
Handle
Auxiliary Connection