Operator`s manual

How to Prevent Damage From Freezing Temperatures
To prevent damage from freezing temperatures, follow this
procedure:
1. Remove any solution remaining in the solution tank.
2. Make sure the machine and pump are completely dry.
3. Pour windshield-type antifreeze into the solution tank
until the screen in the filter is covered.
4. Turn on the vacuum/accessory switch and the spray/
brush switch for 30 seconds.
5. Remove antifreeze solution from the system before us-
ing the extractor.
6. Make sure the machine is the same temperature as the
room before using the machine.
Spray Bar - Nozzles
To clean or quick change the nozzles follow this procedure:
1. Grasp the nozzle, push in and twist 1/4 of a turn to re-
move nozzle from the body.
2. Clean or replace the nozzle.
4. Push in and twist nozzle back into the body.
NOTE: Performance will drop if the factory nozzle configu-
ration is changed.
WARNING: Maintenance and repairs must be done
by authorized personnel only. Keep all
fasteners tight. Use only Clarke parts.
Maintenance performed by someone
other than a Clarke distributor or Clarke
replacement parts could void your war-
ranty.
Electrical
WARNING: Electrical repairs must be done by au-
thorized personnel only.
WARNING: After electrical repairs are done to the
machine, the machine must be tested for
electrical safety.
Page 11 CLARKE Operator's Manual - Image 14