Specifications

12
PARTS IDENTIFICATION
1 ON/OFF Switch
2 Output
current kno
b
Adjusts the cutting current supplied by the machine
according to the thickness of material/speed.
3 Green LED Turns ON when input voltage is applied
blinks slowly when voltage goes above 260V, or below 180V.
4 Red LED Turns ON when torch is triggered. Blinks qu
ickly during 3 second
safety pre-flow prior to pilot arc ignition. Blinks slowly if
cutting arcs not initiated after 3 second pilot arc ignition.
5 Yellow LED ON when the thermal protection is activated.
Blinks slowly when the under pressure protection is working
(the
pressure is less than 3,8 Bar).
6 Air regulator Adjusts the input air pressure - pull upward to unlock -
no
minal air pressure setting is 4,5 Bar.
Note: the regulator should never be set above 6 Bar.
7 Compressed air connection
8 Input cord
9 Work cable with clamp
10 Torch (with a trigger security cap)