Operation Manual

To reset the system:
If you want to clear everything stored in the positioner, including
high/low limits and satellite positions, reset the system with this
procedure:
Press and hold the Reset key on the remote for 10 seconds. It will show
10, 9 … 1, then the positioner will be reset. If the RESET is successful,
the display will show “0000”.
Operation as DiSEqC 1.2 Positioner
Notice: All the commands are from the DiSEqC 1.2 receiver. Refer to the
receiver manual. The name of some commands might be different, but
similar.
Set the Software High/Low Limits:
After you send the commands from the DiSEqC 1.2 receiver, the positioner display will
show LIMITL or LIMITH:
Low Limit High Limit
North Hemisphere East Limit West Limit
South Hemisphere West Limit East Limit
To cancel the Software High/Low Limits:
After you send the command from the DiSEqC1.2 receiver to clear the positioner limit
setting, the positioner display will show “|-- -- -- -- -- --|”on the LED.
Count 0 400 800 1200 1600 2000
Position 01 02 03
Count 0 400 800 1200 1600 2000
New Position 01 02 03
Imported and distributed by satmedia GmbH Germany www.satmedia.com