Installation guide

Tactile Sound Transducers
7
www.clarksynthesis.com
Installation: Overview
3/4”-thick
mounting
surface
Flat Washer
Lock Washer
Jam Nut (up)
3/8”-16
Threaded Stud
Jam Nut (down)
Transducer Lead Wire
Washers
Jam Nuts
Drill 7/16” hole
T-Nut
Drill 7/16” hole
3/8”-16
Hex Bolt
Flat Washer
Maximum 1/4”-thick
mounting
surface
Lock Washer
Jam Nut (up)
Jam Nut (down)
Transducer Lead Wire
Flat Washer
Lock Washer
Jam Nuts
Installation Type: T-Nut Installation Type: Hex Bolt
Minimum 3-1/2” vertical space required,
including 1/2” clearance between the
Transducer and the oor.
Requires initial access to the top of the material to
insert the T-Nut, which installs ush to the surface.
(Drill a 7/16” hole for the T-Nut.)
For use with metal or other high-tensile mounting
surfaces no thicker than 1/4”. Requires access to the
top of the mounting surface both to install the bolt and
to tighten it.
Minimum 3-1/4” vertical space required,
including 1/2” clearance between the
Transducer and the oor.
NEVER TIGHTEN
BY TURNING THE
TRANSDUCER.
MAKE SURE TO
TIGHTEN THE JAM
NUT AGAINST THE
TRANSDUCER’S
BRASS NUT