Installation guide

www.clarksynthesis.com
Tactile Sound Transducers
6
Installation: Overview
Minimum 4-1/2” vertical space required,
including 1/2” clearance between the
Transducer and the oor.
Minimum
3/4”-thick
Joist
(edge view)
Drill 5/16” hole
3/8”-16
Hanger Bolt
Jam Nut (down)
Transducer Lead Wire
Jam Nut
3/4”-thick
mounting
surface
Unimount
Bracket
Flat Washer
Lock Washer
Screw
Jam Nut (up)
Jam Nut (down)
3/8”-16
Threaded Stud
Transducer Lead Wire
Washers
Screw
Jam Nuts
Tip: Tighten
two Jam Nuts
against each
other to screw
in Hanger Bolt
using wrench.
Installation Type: Unimount Bracket Installation Type: Hanger Bolt
NEVER TIGHTEN
BY TURNING THE
TRANSDUCER.
MAKE SURE TO
TIGHTEN THE JAM
NUT AGAINST THE
TRANSDUCER’S
BRASS NUT
Minimum 3-1/2” vertical space required,
including 1/2” clearance between the
Transducer and the oor.
Screws into the bottom of the mounting surface.
Requires access only to the bottom of the mounting
surface. Requires a at or nearly at mounting surface.
Screws into the bottom of the mounting surface (into a
5/16” drilled hole. Requires access only to the bottom
of the mounting surface.