Installation guide

1 Remove AC339 and acoustic sound lens (B) from packaging.

2 Seperate the transducer (A) from the float (G). Using the 9/16”

wrenches, loosen the jam nut to remove the float (G) assembly

from the gold mounting point on the transducer (A). Use one

9/16" wrench to hold the transducer’s (A) gold fastener, and with

the second 9/16" wrench turn the jam nut away from the gold

mounting point until float (G) and transducer (A) are seperated.

3 Remove one jam nut from the threaded stud on float (G) assembly.

Thread jam nut completely onto stud attached to acoustic

sound lens (B). You should now have two jam nuts threaded

completely on to the stud connected to the sound lens (B).

4 Fully thread acoustic sound lens onto transducer (A). Using two

wrenches tighten jam nut against the mounting point. Using one

wrench to hold the transducer’s (A) gold fastener, while the second

tightens the jam nut against the gold mounting point. Make sure that

jam nut is firmly tightened against the gold mounting point. This

assembly is now ready to have a tether attached and be lowered into water.

IMPORTANT NOTE: DO NOT ASSEMBLE BY USING THE DOME

ITSELF TO TIGHTEN—MAKE SURE TO TIGHTEN THE TSTs BY

USING A 9/16” WRENCH ON THE GOLD HEX MOUNTING POINT

AND TURN THE JAM NUT USING A SECOND 9/16” WRENCH.

5 Attach nylon rope* (not supplied) to tether eyelet.

6 Use wire floats (H) as needed.

* Recommended option: A tether (nylon rope) is recommeded

to use to raise, lower, and suspend speaker in water—this can

be purchased at your local hardware or pool supply store.

AQUASONIC DROP-IN INSTALLATION

Tether Eyelet

Floating Assembly

This configuration requires some assembly. A tether is recommended to suspend speaker in water.

Tactile Sound, Full Contact Audio , Improving the Way You Hear and Clark Synthesis Tactile Sound logo, and product names referred

to herein are the registered trademarks of Clark Synthesis, Inc. All other trademarks are the property of their respective owners.

® ®®

™

Aquasonic

TOOLS NEEDED: Phillips Head Screwdriver, 2-9/16" Open-Ended Wrenches.

(B)(G)(A)

(F)

(G)(A)

Jam Nut

(F)

(B)

Jam Nut

(A)

(H)