Installation guide

1 Remove AC339 and acoustic sound lens (B) from packaging.
2 Seperate the transducer (A) from the float (G). Using the 9/16”
wrenches, loosen the jam nut to remove the float (G) assembly
from the gold mounting point on the transducer (A). Use one
9/16" wrench to hold the transducer’s (A) gold fastener, and with
the second 9/16" wrench turn the jam nut away from the gold
mounting point until float (G) and transducer (A) are seperated.
3 Remove one jam nut from the threaded stud on float (G) assembly.
Thread jam nut completely onto stud attached to acoustic
sound lens (B). You should now have two jam nuts threaded
completely on to the stud connected to the sound lens (B).
4 Fully thread acoustic sound lens (B) onto transducer (A). Using two
wrenches tighten jam nut against the mounting point. Using one
wrench to hold the transducer’s (A) gold fastener, while the second
tightens the jam nut against the gold mounting point. Make sure
that jam nut is firmly tightened against the gold mounting point.
This assembly is now ready for installing into a third-party light niche.
IMPORTANT NOTE: DO NOT ASSEMBLE BY USING THE DOME
ITSELF TO TIGHTEN—MAKE SURE TO TIGHTEN THE TSTs BY
USING A 9/16” WRENCH ON THE GOLD HEX MOUNTING POINT
AND TURN THE JAM NUT USING A SECOND 9/16” WRENCH.
5 Remove rubber gasket (#3) from a third-party light niche
face ring assembly (#1) by loosening Phillips head screw on
unitension wire clamp (#2).
6 Wrap rubber gasket (#3) onto acoustic lens’ (B) black rubber ring,
then re-install (#3) with AC339 assembly installed into face
ring (#1). Tighten unitension wire clamp (#2).
7 Insert finished end of underwater speaker cable into conduit
opening in back of light niche (#4). Thread wire through
conduit to junction box.
8 Insert complete assembly into light niche back can (#4) using
pilot screw with captive gum washer (#5) to fasten chrome face
ring assembly (#1) to finish installation.
AQUASONIC IN-WALL INSTALLATION
Please refer to page 5 for exploded diagram and part listing.
1
2
4
3
6
7
8
Pool Wall
Third-Party Light
Niche (#4)
8
Gasket Mounted
onto Sound Lens
Chrome Face Ring
Assembly (#1)
This configuration requires some assembly. The Aquasonic® AC339 simply replaces the light bulb in the light niche.
(B)(G)
(G)
(A)
(B)
(B)(A)
Jam Nut
Jam Nut
Rubber Gasket (#3)Third-Party Light Niche (#4)
TOOLS NEEDED: Phillips Head Screwdriver, 2-9/16" Open-Ended Wrenches.
(A)
(A)
(B)
(A)
(F)
(F)
Pilot Screw
with Captive
Gum Washer
(#5)
Aquasonic
4
Refer to Parts List on Page 2 For Corresponding Part Names.