Installation guide

Tether EyeletStrain Relief Openings
AQUASONIC FLOATING INSTALLATION
Aquasonic
3
3
Underwater Speaker Cable
1 Remove speaker from packaging.
2 Remove wire floats (H) from top of styrofoam packing.
3 Slide wire floats onto the speaker wire, as needed.
4 Attach optional nylon rope of desired length to tether
eyelet hole in rubber ring flange. Nylon rope can
be purchased at pool supply or hardware store.
5 Hook up to stereo (135 watts into 4ohms is recommended).
6 Enjoy!
If speaker shuts off, turn off for approximately 45 seconds to
allow internal protection circuit to reset. Turn down volume.
Use same underwater cable with waterproof connector to
extend cable—extra cable available from Clark Synthesis.
To Stereo System.
4
Suggested Final Assembly Using Wire Floats
(H)
(A)