Installation guide

1. DO NOT DROP SPEAKER - If damage occurs due to high impact of speaker, it is not covered
under warranty.
2. Do not expose speaker to high distortion levels - Excess distortion may result in failure. If
speaker shuts down the built-in protection circuit is signaling that the volume level is too high.
Turn the amplifier off for approximately 45 - 90 seconds to allow the speaker to reset. Operate at
reduced volume. Continued use of high levels of distortion may cause speaker failure, which is
not covered under the warranty.
3. Use a ground fault interrupter - A GFI outlet or extension cable on the sound system will prevent
electrical shock in the event of a malfunction. These are available at hardware stores or home
improvement stores. They are easy to install and provide a safe operating environment for your
electronics and all pool users.
4. Place speaker in pool away from diving boards and high activity areas - Severe injury may
result if speaker is contacted while diving or jumping.
5. Cable placement - Do not place cable in high traffic areas where people may trip or cable may
tangle causing possible drowning or where pets may damage cable.
6. Do not hang speaker by speaker cable - Use a tether (nylon rope) tied to the eyelet on the
speaker, and tie other end to a stationary anchor.
7. Do not drag speaker on pool deck, bottom or side of pool - This may damage speaker. This
damage is not covered under the warranty.
8. Do not remove or alter the watertight fitting from the speaker wire - This fitting is set at the
factory to seal out water. Over tightening may destroy the water-tight seal. Any physical
alteration or damage will void the warranty.
9. Avoid Excessive heat - Do not leave the speaker in direct sunlight unless it is submerged in pool.
High temperatures, as in a closed car, may result in damage and will void the warranty.
10. The built-in protection circuit - If the speaker shuts down, turn the amplifier off for
approximately 45 - 90 seconds to allow the speaker to reset. Restart the amplifier at a lower
volume. The protection circuit is triggered by excessive heat, distortion, or being overpowered.
Continued overload of the protection circuit may cause speaker failure, which is not covered
under the warranty. If symptoms persist the system may need to be configured differently.
Contact Clark Synthesis or your local dealer for assistance.
GENERAL SAFETY INSTRUCTIONS
!
Thank you for purchasing the Aquasonic® AC339 from Clark Synthesis Tactile Sound. Please read
the following instructions before assembling and using the product.
Aquasonic
1