AQUASONIC POOL SPEAKER INSTALLATION GUIDE Clark Synthesis, Inc. • 8020 Southpark Circle, Suite 600 • Littleton, CO 80120 • www.clarksynthesis.
! GENERAL SAFETY INSTRUCTIONS Thank you for purchasing the Aquasonic® AC339 from Clark Synthesis Tactile Sound. Please read the following instructions before assembling and using the product. 1. DO NOT DROP SPEAKER - If damage occurs due to high impact of speaker, it is not covered under warranty. 2. Do not expose speaker to high distortion levels - Excess distortion may result in failure. If speaker shuts down the built-in protection circuit is signaling that the volume level is too high.
INDEX OF CONFIGURATIONS Portable Floating Model Page 2 In-Wall Model (Shown with Third-Party Light Niche) Page 3 Portable Drop-In Model Page 5 SUPPLIED/REQUIRED ITEMS Supplied Parts Required Tools and Materials A. B. C. D. E. F. G. H. • • • Third-Party Light Niche Part • #2 Phillips Screwdriver • (2 ea.) 9/16" Open-Ended Wrenches (1 ea.) Aquasonic Transducer (1 ea.) Acoustic Sound Lens (3 ea.) Jam Nut (1 ea.) Stainless Steel Stud (2 ea.) Stainless Steel Washers (1 ea.) Acoustic Radiator (1 ea.
AQUASONIC FLOATING INSTALLATION 1 Remove speaker from packaging. 2 Remove wire floats (H) from top of styrofoam packing. 3 Slide wire floats onto the speaker wire, as needed. 3 Underwater Speaker Cable (H) 4 Attach optional nylon rope of desired length to tether eyelet hole in rubber ring flange. Nylon rope can be purchased at pool supply or hardware store. 5 Hook up to stereo (135 watts into 4ohms is recommended).
AQUASONIC IN-WALL INSTALLATION This configuration requires some assembly. The Aquasonic® AC339 simply replaces the light bulb in the light niche. TOOLS NEEDED: Phillips Head Screwdriver, 2-9/16" Open-Ended Wrenches. Refer to Parts List on Page 2 For Corresponding Part Names. 1 1 Remove AC339 and acoustic sound lens (B) from packaging. (A) (F) (G) 2 Seperate the transducer (A) from the float (G).
IN-WALL ASSEMBLY PARTS LIST Item # 1 2 3 4 5 Parts Supplied By Third Party Part No. 79110600 79111000 79101600 00782105 79104800 Description Face ring assembly, stainless steel Unitension wire clamp assembly Gasket for 8-3/8” lens Light niche Pilot screw with captive gum washer Parts Supplied By Clark Synthesis/Aquasonic Item # A B C D Part No.
AQUASONIC DROP-IN INSTALLATION This configuration requires some assembly. A tether is recommended to suspend speaker in water. TOOLS NEEDED: Phillips Head Screwdriver, 2-9/16" Open-Ended Wrenches. 1 Remove AC339 and acoustic sound lens (B) from packaging. 1 (A) (G) (F) 2 Seperate the transducer (A) from the float (G). Using the 9/16” wrenches, loosen the jam nut to remove the float (G) assembly from the gold mounting point on the transducer (A).
United States Warranty and Return Policy AC339-AQUASONIC POOL SPEAKER WARRANTY Clark Synthesis, Inc. warranties the AC339-Aquasonice Pool Speaker to be free from defects and workmanship under normal use for a period of one (1) year from date of original purchase. For industrial or commercial use, the warranty period is six (6) months. Should warranty service be necessary, Clark Synthesis, Inc. will (at its discretion) repair or replace the defective merchandise with equivalent merchandise at no charge.
