User`s guide

WN-5220-V VideoWall User’s Guide
41
Reset Lamp Hours
After a lamp change, use this menu to reset the lamp hour timer to
zero. The system hour timer displays the total hours that power has
been applied to the VideoWall with the power supply switch on. The
system hour timer cannot be reset. Lamp hours accrue when the
VideoWall is running (FAN and LAMP LED’s are on solid).
Source Select
Frequency
Phase
Input Level
Position
Zoom
Color Balance
Curtain
Hours
Save Config
Recall Config
Reset Config
Misc Control
About
Lamp Hours: 0243
System Hours: 0886
Reset Lamp Hours?
[ ] Yes [X] No
1. Press the MAIN MENU
button on the remote
The Main menu is displayed.
2. Press the up/down
arrow keys
Move the cursor to the Hours selection.
3. Press ENTER
The Lamp Hours menu displays the current number of
lamp operating hours. Replace the lamp at 3000 hours.
This menu also shows total system hours.
4. Press left/right arrow
keys
Use the left or right arrow keys to highlight the Yes
selection.
5. Press ENTER
Press the ENTER button to proceed in resetting the lamp
hours to zero.
6. Press left/right arrow
keys
At this point a warning will prompt ‘Did You Replace The
Lamp?’ If the lamp was replaced, use the left or right
arrow keys to highlight the Yes selection.
7. Press ENTER
Press the ENTER button to proceed in resetting the lamp
hours to zero.