User`s guide

WN-5220-V VideoWall User’s Guide
35
8. Set the Wall Size on each
display
Open the Wall Processor menu. Enter the horizontal
and vertical number of displays in the wall. Each
display should show the same horizontal and vertical
wall size.
Each display should show a different Current Unit
value. This value represents its location in the wall.
9. Put each display into Wall
Mode
Move the menu cursor to the Calc wall pos line and
press the ENTER button. This calculates the position
of the selected display within the image and puts the
display into wall mode. The display will now show only
its segment of the overall image.
Do this with each display in the wall and exit the Wall
Processor menu.
10. Fine tune the wall image
If Step 2 was done correctly, the image in each display
should not need to be adjusted by more than two lines
in any direction.
If an adjustment to the image must be made, use the
scaling function in the Zoom menu to move only the
edge that needs adjustment.
11. Save the settings
Open the Save Config menu and save the settings for
each display.
If there are other video sources that will use Big Picture, go back to Step
2 and select that source. Then go through all the remaining steps.