User`s guide

WN-5220-V VideoWall User’s Guide
31
Turning off the System
Turn off the Lamp, Enter Standby Mode
The main power switch is left on and the units remain in standby
mode until turned on again. Use the remote to turn off the lamp and
enter standby mode.
1. Press the remote
control OFF
button – or the
hard-wired
REMOTE
ON/STBY switch
– or the POWER
button on the
rear connector
panel
The unit is placed in the standby delay mode and the
lamp is shut off and locked out for 3 minutes. The fans
continue to operate during lockout to ensure proper
cooling. Three beeps will sound if an attempt is made to
turn on the units during the 3 minute lockout.
During the standby delay cycle the STBY LED on the rear
connector panel will blink.
Turn off Main Power Switch
Turn off the main power switch only for servicing or moving the
VideoWall or if the display will not be used for an extended period of
time. If the unit is turned off at the main power switch, the 3 minute
power up described on page 14 is required.
1. Turn off main
power switch
The main power switch is located next to the AC power
plug at the back of the VideoWall.