User`s guide

WN-5220-V VideoWall User’s Guide

Initial Setup

After the VideoWalls are installed, follow these steps for

each

display

unit:

Step 1 - Power-Up

Step 2 - Adjust the Input Signal Settings

Step 3 - Adjust the Colors

Step 4 - Save the Settings

Step 1 – Power-Up

CAUTION

100 Volt Users –

Set the red voltage switch at the

power plug on the power supply to 115V.

CAUTION

115 Volt Users -

Set the red voltage switch at the

power plug on the power supply to 115V.

CAUTION

230 Volt Users -

Set the red voltage switch at the

power plug on the power supply to 230V.

1. Turn the main power

switch (next to the

power cord) to the ON

(1) position

The STBY LED flashes, indicating the power up cycle has

begun. Wait approximately three minutes until the STBY

LED is on continuously.