User`s guide

WN-5220-V VideoWall User’s Guide
11
Mechanical Setup
Install the WN-5220-V VideoWall in the desired position and connect
the power and signal cables. See the following section for an
explanation of the cabling configuration.
Figure 1
To setup the WN-5220-V VideoWall in a video wall configuration,
follow these steps:
1. Remove the screen
from each unit to be
used in the video wall.
Keep each screen with it’s unit. See Screen on page 45.
Place the screen where it will not be damaged.
2. Build the video wall.
Build on a level floor strong enough to hold the weight of
the finished assembly. See Flooring on page 9 for weight
information
3. Assemble the lower row
first.
Line up the legs as straight as possible.
Insert a ¼” X 2 ½” bolt through the holes as shown in
Figure 1
. Tighten a nut securely on this bolt.
Secure the legs to the floor using the tapped 5/16-18
holes in the front and rear of the legs when stacking more
than two units high or use the optional
BAS-520
base to
secure the WN-5220-V.
4. Stack the next higher
row.
Sliding the legs of each VideoWall into the mating sockets
of the VideoWall in the first (lower) row.
5. Insert a su
pp
lied
Insert a bolt through the hole in side wall of the lower unit