User`s guide

WN-5220-S VideoWall User’s Guide
74
Use the remote control or RS-232 input
for all setup and control functions.
The remote must be pointed directly at
the display’s screen when the remote is
used to access the items in the menu.
The most reliable position for control of
the display is on an axis perpendicular to
the front of the screen.
The farther away that the remote control is from the display, the weaker the
signal will be that reaches the screen. The weaker the signal, the less
reliable the control of the display will be. The remote is powered by two 1.5
volt AAA batteries.
Remote Control Functions
Some on-screen sub-menus can be accessed directly by pressing the
specific menu item’s associated button on the remote control.
Remote Button Description
On
If the main power breaker on the rear is on, and the 3-minute delay period
has been completed so the STBY LED is on and
not
blinking, this button
turns on the lamp.
Off
Turns the lamp off immediately. The fan will remain on for 3 more
minutes. The lamp may not be turned on again until this 3-minute period
is finished.
Source
Displays the Source Select menu, from which the type of input source,
PC, MAC, and RGBS 31.5 kHz video. With the VIM-300 option, RGBS
15.75 kHz video, Composite video and S-Video may be selected.
Curtain
Toggles between the selected video and a black screen.
Level
Displays the Input Level menu, where input levels for black and white are
set. These can be set automatically.
Phase
Displays the Phase Select menu, for synchronizing the WN-5220-S
internal clock to the clock phase of the incoming signal.
Freq
Displays the Frequency Select menu, for matching internal clock
frequency to source frequency (for computer sources) and for adjusting
horizontal width for video sources.
Color
Displays the Color Balance menu, which allows color and luminance
matching among the several WN-5220-S displays in a video wall.
Reset
Displays the Reset Menu. From here, you can reset some or all sources
and modes to factory default settings. This does
not
affect the Saved
settings unless you Reset, then Save.