User`s guide

ManualsBrandsClarity ManualsComputer equipmentWN-5220-V

WN-5220-S VideoWall User’s Guide

for Standard Mullion screens only, by first removing the screen (see

Removing Standard Mullion Screens on page 17), or from the rear by

removing the lamp service access cover. Lamps are most easily

replaced from the rear for Thin Mullions Screens.

WARNING

Before servicing the display, always switch the AC power off at

the

rear

panel power switch and remove the power cord.

When the WN-5220-S VideoWall is connected to the electrical

mains, some circuits still contain line voltage, even when power

is switched off.

CAUTION

Do not

touch

the lamp or reflector. Oils from the skin will cause

these surfaces to become etched when the lamp is operated,

dramatically shortening the life of the lamp.

1. Turn off the power

Switch off the WN-5220-S using the remote and allow the cooling cycle

to complete (3 minutes) before switching off the AC power at the rear-

panel switch.

2. Unplug power cord

Remove the AC power cord from the WN-5220-S.

3. Remove screen or

lamp access cover

For Standard Screen units, to gain access to the lamp from the front

unit, remove the screen.

For either screen type, to gain access to the lamp from the rear unit,

unfasten the 8 quarter-turn screws on the lamp access cover and

remove the cover.

4. Unplug lamp

connector

The lamp connector is next to the reflector fan. Unplug the connector by

pulling up on it.

5. Unhook the lamp

Unhook the two latches holding the lamp module to the optical

assembly.

6. Remove the lamp

Lifting up on the handle, tilt the lamp module away from the latches until

it can be pulled free of the optical assembly.

Carefully remove from the display by lifting the lamp module straight up

to clear the fans, and then withdrawing.

7. Install new lamp

Replacement is the reverse of the above procedure. After installing the

lamp module, ensure that the high-voltage connector is in place and that

the latches are securely latched before replacing the screen or the lamp

service access cover.

8. Reset the Lamp Hours

Reset the lamp hours in the menu.